MediaWiki API result
This is the HTML representation of the JSON format. HTML is good for debugging, but is unsuitable for application use.
Specify the format parameter to change the output format. To see the non-HTML representation of the JSON format, set format=json.
See the complete documentation, or the API help for more information.
{
"batchcomplete": "",
"query": {
"searchinfo": {
"totalhits": 8
},
"search": [
{
"ns": 0,
"title": "Arcade Machine Restoration Monitors",
"pageid": 1479,
"size": 2800,
"wordcount": 496,
"snippet": "...g about that little strip, how did it get there? Did they remove the yoke, <span class='searchmatch'>meaning</span> convergence had to be started again? Maybe it was slipped under, which is w\n",
"timestamp": "2013-02-21T11:23:14Z"
},
{
"ns": 0,
"title": "PCB Repair Logs Rainbow Islands",
"pageid": 412,
"size": 13772,
"wordcount": 2532,
"snippet": "...or every address location it specifies. The ROMs and SRAMs were all 8 bit, <span class='searchmatch'>meaning</span> they have 8 data lines so when fed an address they can only spit out 8 bits\n",
"timestamp": "2013-02-06T23:17:46Z"
},
{
"ns": 0,
"title": "PCB Repair Logs Pong",
"pageid": 800,
"size": 7735,
"wordcount": 1394,
"snippet": "...and i could see that the output from pins 9-14 were all just jammed at 5v, <span class='searchmatch'>meaning</span> they were switched on the whole time. I grounded pin 4 and found the output\n",
"timestamp": "2012-08-30T06:24:16Z"
},
{
"ns": 0,
"title": "PCB Repair Logs Raiden DX",
"pageid": 264,
"size": 10471,
"wordcount": 1915,
"snippet": "...emporarily join the mask rom pin to the 373 to prove the fault, and I keep <span class='searchmatch'>meaning</span> (and forgetting) to make a lead with a probe at each end. So I did this..\n",
"timestamp": "2013-02-06T23:10:59Z"
},
{
"ns": 0,
"title": "PCB Repair Logs Indiana Jones and The Temple Of Doom",
"pageid": 564,
"size": 15882,
"wordcount": 2908,
"snippet": "...power rails can be a sign that the PSU is struggling to keep the volts up, <span class='searchmatch'>meaning</span> the wiring between the PSU and the board is too thin. This board has an edg\n",
"timestamp": "2013-02-06T02:33:02Z"
},
{
"ns": 0,
"title": "PCB Repair Logs Vindicators",
"pageid": 743,
"size": 15528,
"wordcount": 2876,
"snippet": "...n't want anyone to read out the contents again he could set a security bit <span class='searchmatch'>meaning</span> if you didn't already have the data you had no chance of making a new chip,\n",
"timestamp": "2013-02-07T02:27:32Z"
},
{
"ns": 0,
"title": "PCB Repair Logs Psycho Soldier",
"pageid": 947,
"size": 20235,
"wordcount": 3762,
"snippet": "...and only a few 6116's on the bottom board, Sod's Law seemed to be in play <span class='searchmatch'>meaning</span> the fault was going to be on the least accessible of the 3 boards. The trou\n",
"timestamp": "2013-02-06T22:53:59Z"
},
{
"ns": 0,
"title": "PCB Repair Logs Midnight Resistance",
"pageid": 455,
"size": 40566,
"wordcount": 7313,
"snippet": "...didn't have the handbrake on) - all good! However the "halt" pin was low, <span class='searchmatch'>meaning</span> the CPU had crashed, pretty much anything that causes the CPU to get scramb\n",
"timestamp": "2013-02-06T04:04:09Z"
}
]
}
}