Difference between revisions of "PCB Repair Logs Pengo"
m |
m |
||
| Line 15: | Line 15: | ||
</tr> | </tr> | ||
</table></p> | </table></p> | ||
<br> | |||
'''Repairer:''' [http://www.aussiearcade.com.au/member.php/1-Arcade-King Arcade King]<br> | '''Repairer:''' [http://www.aussiearcade.com.au/member.php/1-Arcade-King Arcade King]<br> | ||
'''Forum Thread:''' [http://www.aussiearcade.com.au/showthread.php/50-Pengo Pengo PCB Repair]<br> | '''Forum Thread:''' [http://www.aussiearcade.com.au/showthread.php/50-Pengo Pengo PCB Repair]<br> | ||
| Line 30: | Line 30: | ||
'''Fix:''' Fool who made the harness wired the sync on the JAMMA fingerboard in the wrong place and no it wasn't me!</p> | '''Fix:''' Fool who made the harness wired the sync on the JAMMA fingerboard in the wrong place and no it wasn't me!</p> | ||
<br> | <br> | ||
Revision as of 12:41, 20 August 2012
Pengo
 |
|
| PCB Image | Reserved |
|---|---|
| Pin Out | Reserved |
Repairer: Arcade King
Forum Thread: Pengo PCB Repair
This one just fixed and was one of the first boards I ever worked on. This board had a few problems.
Symptom:The background of the game was blue instead of black and all the green snow bees were missing and just blocks the rest of the graphics were fine.
Fix: Bad N82S137N Colour Prom at IC88
Funny this one, In my eternal stupidness When I was fault finding I accidently put the colour prom in backwards(not the first time i've done this either!). Ordered another prom popped her in and fixed all the problems in the game! ROFL KARMA IS REAL.
Symptom: No sound
Fix:Amp was fried and was around the wrong way anyway. Replaced amp with one from a scrap Kid Niki board
There was also a bad cap at C24
Symptom: No sync
Fix: Fool who made the harness wired the sync on the JAMMA fingerboard in the wrong place and no it wasn't me!
Repairer: Prof
Forum Thread: Pengo PCB Repair
Pengo. Original PCB. Should apply to the bootlegs.
Sound Distorted. Locks up or resets when trying to draw maze. Something starts without drawing maze.
OK, suspect something happening when it trys to play sounds as all sounds are clipped/out of tune. Have a poke around with a logic probe at anywhere where the 2 ciruits meet the data bus, and find a dead 74LS174 with no outputs.
Seems it times the 2 busses. Pulled and replaced. Game good to go.
IC 48 at fault. Replaced, game now 100%
Repairer: VectorGlow
Forum Thread: Pengo PCB Repair
Symptom: Sprites had no eyes or other details
Cure: 74LS367 at location IC102 (4P) needed to be re-seated in its’ socket
Symptom: Sound was distorted when board was cold, but improved as it heated up
Cure: Replaced 82S129 PROM at location IC70 (2K) – this uses MAME PROM image: PR1636.070
