PCB Repair Logs Run And Gun
From Aussie Arcade Wiki
Jump to navigationJump to searchRun And Gun
 |
|
| PCB Image | Reserved |
|---|---|
| Pin Out | Reserved |
Repairer: trol
Forum Thread: Run And Gun PCB Repair
The sprites on this one were messed up, there were vertical lines in the players and some bits were out of place.
Did the mask rom test in the game menu and 5U was showing as bad. This mask rom is a HN624116P, the eprom equivalent is a 27c160-100.
Programmed the data on the eprom, slapped it in and the fault is gone.
Another one saved from the scrap-heap
