PCB Repair Logs Kung-Fu Master
From Aussie Arcade Wiki
Jump to navigationJump to searchKung-Fu Master
 |
|
| PCB Image | Reserved |
|---|---|
| Pin Out | Reserved |
Repairer: VectorGlow
Forum Thread: Kung-Fu Master PCB Repair
Symptom: Graphics very garbled, no more than character blocks with miscellaneous bits and pieces in them. Sprites can sometime be made out and the main area scrolls as it should as the game does play
Cure: Bad outputs on the LS367 at location 5F on the middle board
Symptom: Some bits not flipping on DIP switch 1
Cure: DIP switch was okay, some bad outputs on the LS367 at location 1B on the middle board
Note: both affected chips were made by Fujitsu (a common point of failure on boards of this era (1984))
