PCB Repair Logs Kung-Fu Master

From Aussie Arcade Wiki
Revision as of 08:57, 21 August 2012 by Brad (talk | contribs)
Jump to navigationJump to search

Kung-Fu Master

Kung-Fu Master
Marquee kung fu master.jpg
PCB Image Reserved
Pin Out Reserved

Repairer: VectorGlow
Forum Thread: Kung-Fu Master PCB Repair

Symptom: Graphics very garbled, no more than character blocks with miscellaneous bits and pieces in them. Sprites can sometime be made out and the main area scrolls as it should as the game does play
Cure: Bad outputs on the LS367 at location 5F on the middle board

Symptom: Some bits not flipping on DIP switch 1
Cure: DIP switch was okay, some bad outputs on the LS367 at location 1B on the middle board

Note: both affected chips were made by Fujitsu (a common point of failure on boards of this era (1984))


Back to PCB Repair Index