Difference between revisions of "PCB Repair Logs Run And Gun"
From Aussie Arcade Wiki
Jump to navigationJump to search (Created page with "==Run And Gun== <p><table class="infobox vevent" style="width:22em;" cellspacing="5"> <caption class="summary" style=""><b>Run And Gun</b></caption> <tr class="> <td colspan="...") |
m |
||
| Line 18: | Line 18: | ||
'''Forum Thread:''' [http://www.aussiearcade.com.au/showthread.php/49362-Konami-Run-amp-Gun-repair-log Run And Gun PCB Repair]<br> | '''Forum Thread:''' [http://www.aussiearcade.com.au/showthread.php/49362-Konami-Run-amp-Gun-repair-log Run And Gun PCB Repair]<br> | ||
<br> | <br> | ||
The sprites on this one were messed up, there were vertical lines in the players and some bits were out of place. | |||
Did the mask rom test in the game menu and 5U was showing as bad. | |||
This mask rom is a HN624116P, the eprom equivalent is a 27c160-100. | |||
Programmed the data on the eprom, slapped it in and the fault is gone. | |||
Another one saved from the scrap-heap | |||
<br> | <br> | ||
<br>[[PCB_Repair_Index|Back to PCB Repair Index]] | <br>[[PCB_Repair_Index|Back to PCB Repair Index]] | ||
Revision as of 09:43, 6 September 2012
Run And Gun
 |
|
| PCB Image | Reserved |
|---|---|
| Pin Out | Reserved |
Repairer: trol
Forum Thread: Run And Gun PCB Repair
The sprites on this one were messed up, there were vertical lines in the players and some bits were out of place.
Did the mask rom test in the game menu and 5U was showing as bad. This mask rom is a HN624116P, the eprom equivalent is a 27c160-100.
Programmed the data on the eprom, slapped it in and the fault is gone.
Another one saved from the scrap-heap
