PCB Repair Logs Run And Gun

From Aussie Arcade Wiki
Revision as of 07:33, 7 February 2013 by Brad (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

Run And Gun

Run And Gun
Marquee run and gun.jpg
Manufacturer Konami
Year 1993
PCB Image Reserved
Pin Out Jamma

Repairer: trol
Forum Thread: Run And Gun PCB Repair

The sprites on this one were messed up, there were vertical lines in the players and some bits were out of place.

Did the mask rom test in the game menu and 5U was showing as bad. This mask rom is a HN624116P, the eprom equivalent is a 27c160-100.

Programmed the data on the eprom, slapped it in and the fault is gone. Another one saved from the scrap-heap


Back to PCB Repair Index