PCB Repair Logs Wonderboy 3 Monster Lair

From Aussie Arcade Wiki
Revision as of 13:09, 4 February 2013 by Brad (talk | contribs)
Jump to navigationJump to search

Wonderboy 3 - Monster Lair

Wonderboy 3 - Monster Lair
Monsterland marquee.jpg
PCB Image Reserved
Pin Out [[]]

Repairer: GameDude
Forum Thread: Wonderboy 3 Monster Lair PCB Repair

Problem was with sprites.

Pcb repair wonderboy in monsters lair 1.jpg

when cold all was good and when warm the sprites all glitched up into a single column up the screen.

To find the correct ram location for sprites I opted for the not so tactful method of shorting two data pins on each ram until I found screen corruption that matches the problem. Its a rough guide but handy if you know what to look for.

Pcb repair wonderboy in monsters lair 2.jpg

When looking for ram faults in this way one thing to remember is NOT to short power pins!! only short data or address pins with another next to that pin, also doing this to ram running game code or ram for audio will probably reset the PCB so dont bother doing this to ram close to the main CPU.

It only took a few minutes to suss the bad ram out and I then used a method of cold spray and hot air from a rework station to isolate which ram in the bank was bad.

Pcb repair wonderboy in monsters lair 4.jpg

It turns out freezing IC12 would correct the sprites and heating would make it fail, a quick desolder socket and replacement 6116 ram and all is now good!

Pcb repair wonderboy in monsters lair 3.jpg

One more thing is to make sure your PCB has good power, I have seen many home brew harnesses that do not have enough wire connected to enough pins to carry enough current for the whole PCB and the same type of fault is merely down to not enough power at the far end of the PCB.



Back to PCB Repair Index